Got Plumbing Problems? Use These Easy Tips!

Look no further than this article for the greatest plumbing advice that you will ever find. You are concerned about either current issues that you are having or things that might occur in the future. Read the advice carefully in this article and you will be more than satisfied.

You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.

To avoid having your outdoor faucets freeze up in the winter, detach all hoses before the first freeze. Also, close the shutoff valve that leads to the outdoor faucets, then turn on the outdoor faucets to let any remaining water in the lines drain. Once temperatures warm up in the spring, you can reverse the process.

To avoid wasting water and having a potentially high water bill, check your home for leaky faucets periodically. Fix any leaks that you find right away. You may be able to do the repair yourself, but if not, you may have to seek the services of a plumber to make the repairs.

If you have bad water pressure in the shower, the showerhead might be clogged. Take a plastic baggie, fill it with regular vinegar, and tie it to the showerhead so that the showerhead is covered. Leave it overnight. In the morning, take the baggie off and use a small toothbrush to scrub away any mineral deposits.

READ  Save Money With These Interior Design Tips

Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

In conclusion, there is a lot to know about plumbing and not all of the advice available is useful. Ideally, this article either provided you with new knowledge or it allowed you to solidify current knowledge. Use this great information today and you will be set up for success with any plumbing project.